| Make | Model | Problem | Solution | Date |
| | | |
| Found: 12
|
| Ferguson | ICC5 59K5 | Int trips off or failure to start | Prot I/P at pin 28 IL14 TEA2029C being turned on. Dry joint RL18 4k7 (near pin 1 of LOPTx) | 14-09-04 |
| Sony | FE-1 KV25K5U | Int reverts to st/by with LED flashing 5 times | CRT internal s/c - replaced under guarantee - very prone to this fault apparently | 14-09-04 |
| Sony | FE-1 KV25K5U | lines across screen, frame IC running hot | C506 0.01 uF | 14-09-04 |
| Sony | FE-1 KV25K5U | not starting up, LED flashes 4 times | T511 breaking down at switch on, replace T511 (145326411 for 25", 145326511 for 29") | 14-09-04 |
| Sony | FE-1 KV29K5U | dead, in stby | C515 220uF 25V s/c | 14-09-04 |
| Sony | FE-1 KV29K5U | no remote operation | D907 BZX79C9V1 leaky on SIRCS line | 14-09-04 |
| Sony | FE-1 KV29K5U | pink band on LHS, only obvious on dark bachground | video lead from CN504 on A PCB to CN704 on CRT wrapped around L537 (LINE LIN), tie bottom edge of loom to the hole provided in top right corner of S PCB | 14-09-04 |
| Sony | FE1 KV25K5U | Dead with LED flashing 4 times | Check for 9v at pins 33 & 34 IC301. If present, check R546 47R 1/2w for o/c (135v Line dr supply) | 14-09-04 |
| Sony | FE1 KV25K5U | No R/C op - hset ok | D011 5v6 zener on o/p of Rx leaky | 14-09-04 |
| Sony | FE1 KV25K5U | Trips off with a crack - LED flashes 5x | CRT faulty | 14-09-04 |
|
|
| Sony | KV25K5U | LED flashes twice - LOPTr s/c but still goes s/c at sw on even with LOPTx replaced | Q635 line driver & check R546 47R feed res | 14-09-04 |
| Sony | KV25K5U | LED flashes twice at sw on - LOP problems | LOPTr 2SD2539 s/c - expensive - caused by dry joints line dr trfmr | 14-09-04 |