Make | Model | Problem | Solution | Date |
| | | |
Found: 32
|
Sony | BE-3B KV25T1U | dead, no start up | R600 39k 5W in PSU (1-216-490-11) | 14-09-04 |
Sony | BE-3D KV25F3U | dead, no 135V | o/c print around D609 | 14-09-04 |
Sony | BE-3D KV25F3U | no audio output | no +21V, PS602 2.7A o/c (153268621) | 14-09-04 |
Sony | BE-3D KV25X1U | burst of EHT for 5 sec, then dead | LOPTx (145316912) | 14-09-04 |
Sony | BE-3D KV25X1U | dead, HT down to 24V | no 5V supply, replace IC604 (875936613) | 14-09-04 |
Sony | BE-3D KV25X1U | dead, no LED | IC600 STRS6707, R605 0.27R o/c | 14-09-04 |
Sony | BE3B KV25T1U | No pic, sound & EHT OK | R824 1k8 burnt & C815 dry joints | 14-09-04 |
Sony | BE3D KV25X1U | E/W faulty | Q800 in pin cush out cct leaky | 14-09-04 |
Sony | BE3D KV25X1U | LED flahes 19 times at sw on | Multiple devices not acknowledging - Fuse PS603 o/c | 14-09-04 |
Sony | BE4A KV25T1U | Corrugations and poor EHT stability | LOPTx | 14-09-04 |
|
Sony | FE KV25X5U | Int no pic with LED flashing 4 times | O/C print from pin 14 of IC301 to first link wire. | 14-09-04 |
Sony | FE-1 KV25K5U | Int reverts to st/by with LED flashing 5 times | CRT internal s/c - replaced under guarantee - very prone to this fault apparently | 14-09-04 |
Sony | FE-1 KV25K5U | lines across screen, frame IC running hot | C506 0.01 uF | 14-09-04 |
Sony | FE-1 KV25K5U | not starting up, LED flashes 4 times | T511 breaking down at switch on, replace T511 (145326411 for 25", 145326511 for 29") | 14-09-04 |
Sony | FE-1 KV25X5U | comes on then goes off, red LED is on | stby IC609 TOP209P u/c | 14-09-04 |
Sony | FE-1 KV25X5U | yellow line down screen about 2 inches from RHS | IC301 CXA2060BS (875208838) | 14-09-04 |
Sony | FE1 KV25K5U | Dead with LED flashing 4 times | Check for 9v at pins 33 & 34 IC301. If present, check R546 47R 1/2w for o/c (135v Line dr supply) | 14-09-04 |
Sony | FE1 KV25K5U | No R/C op - hset ok | D011 5v6 zener on o/p of Rx leaky | 14-09-04 |
Sony | FE1 KV25K5U | Trips off with a crack - LED flashes 5x | CRT faulty | 14-09-04 |
Sony | FE1 KV25KSU | FRAME IC HOT LINES ON SCREEN | REPLACE C506 0.01MFD | 14-09-04 |
Sony | FE1 KV25X5U etc | Enters search mode as soon as its switched on | replace SS902 preset search switch and clean PCB that it is
mounted in | 14-09-04 |
Sony | FE1A KV25FX20D | St/by only - flashes twice (prot mode) | IC606 STRF6654 low res of 140R between pins 4 & 5 (should be 3M) | 14-09-04 |
Sony | KV2500WX | Field poor lin & top/bottom foldover | C558 560µ | 14-09-04 |
Sony | KV2553 | East-West, reduced width. TEA2031 replacement failed. | Change C830 and C831 1uF caps. | 14-09-04 |
Sony | KV2562 | COLOUR FLICKERS OFF AFTER 30mins | IC301 | 14-09-04 |
Sony | KV2576UB | NO RASTER - FIELD COLLAPSE BUT BLANKED OUT | CHECK RES IN SERIES WITH D804 | 14-09-04 |
Sony | KV25F2 | Ragged verts | Could be LOPTx, D505 3v6 in prot cct or EEPROM | 14-09-04 |
Sony | KV25F3U | Service Mode entering | switch off (mains); -while pressing volume + and - on the front of the set switch on; - osd "TT" appears; -press "menu" | 14-09-04 |
Sony | KV25K5U | LED flashes twice - LOPTr s/c but still goes s/c at sw on even with LOPTx replaced | Q635 line driver & check R546 47R feed res | 14-09-04 |
Sony | KV25K5U | LED flashes twice at sw on - LOP problems | LOPTr 2SD2539 s/c - expensive - caused by dry joints line dr trfmr | 14-09-04 |