| Make | Model | Problem | Solution | Date |
| | | |
| Found: 51
|
| Akai | CT2107MS (Onwa) | Int off with blob in centre of screen | Check for hairline cracks around chopper tfmr pins | 14-09-04 |
| Blaupunkt | MS70-76 FM 100-30 | black screen | U2(200V) is missing at CRT pcb. Check fuse S720 and R1853(3K3)+V1855 (BF421) on video module. +evt. R1816+V1815 | 14-09-04 |
| Blaupunkt | MS70-76 FM 100-30 | No start up at power on | C450 100uF/25Vin psu between TDA 4601 & base V450. Also check L452 in Coll of V450 & all comps in psu. Recomend fit 10k between pin 1 & 9 of TDA 4601 | 14-09-04 |
| Blaupunkt | MS70-76 FM 100-30 | Relay clicks at sw on - otherwise dead | C441 1uF & R440 330k in psu area; 11v at V410 front left in front of modules ( measures 8 volt in Stby ) | 14-09-04 |
| Blaupunkt | MS70-76 FM 100-30 | Reverts to st/by at sw on | C450 (100uF/25V) in psu area | 14-09-04 |
| Bush | 2850NTX-MS | slow start up - reset problem | IC101 pin 33 needs 4.8v to start up mod - add 1µ & 100k res to 5v line | 14-09-04 |
| Bush | 2850NTX/MS | no graphics, front panel buttons are inoperative, remote is inoperative,no sound, no picture - only blank full size raster with 4-5 coloured horizontal lines on the screen. | no flyback supply voltage to frame IC TDA8351 pin 6 caused by R438 0.22 Ohm o/c (near LOPT). | 14-09-04 |
| Ferguson | ICC19 Thomson 32WS83KP | starts up then trips and shuts down | IB01 TEA5101B on CRT | 14-09-04 |
| Ferguson | TX807 Thomson 14MS15UT | dead, no LED | DP25 RGP10 s/c | 14-09-04 |
| Ferguson | TX91 Thomson 10MH73B 10MG73B | dead | SMD TF21 near LOPTx not soldered in factory | 14-09-04 |
|
|
| Ferguson | TX91 Thomson 10MH73B 10MG73B | dead on 12V supply (car supply) | RD09, RD19 22R 0.5W fusible | 14-09-04 |
| ITT | LATE SLIM Slimline | WONT ALWAYS START , COMES ON WHEN WARM | CHECK 4.7mfd 400v POWER | 14-09-04 |
| Loewe | MS56 | Startup - no sound or picture. | R534 ( 3.3R ) o/c , check C638 ( 1uf ) | 14-09-04 |
| Loewe | MS56 | This set's picture was marred by very severe Venet | 1k LZ AMP preset P323 had gone open-circuit. | 14-09-04 |
| Loewe | MS56 C8001 | Stuck in standby. | R534 ( 3.3R ) o/c , T534 , C534 ( 47uf ) | 14-09-04 |
| Loewe Opta | MS124 | POOR FIELD LIN | C581 47uF 63v | 14-09-04 |
| Loewe Opta | MS56 C8001 | Dead. | LOPT SC , R583 OC 22R , IC1581 SC TDA4950 | 14-09-04 |
| Loewe Opta | MS56 C8001 | DEAD STBY LED LIGHT R534 LINE DRIVER FEED OC | REPLACE R534 3R3 T534 C534 | 14-09-04 |
| Lowe | MS56 C8001 | Dead - st/by only | Line dr Tr supply res R534 3R3 o/c also check C534 47µ | 14-09-04 |
| Lowe | MS56 C8001 | Dead after smelling hot | C652 47µ 250v HT cap leaky/ burnt conns | 14-09-04 |
| Lowe | MS56 C8001 | High HT (should be 142v) | C638 1µ | 14-09-04 |
| Lowe | MS56 C8001 | Venetian blinds | P323 1k LZ AMP preset o/c | 14-09-04 |
| Mitsubishi | CT14MS1BM | Intermittent field jitter . | Dryjoint at R461. | 14-09-04 |
| Mitsubishi | CT14MS1BM | pic shifted to right | dry joint R527 near lopt | 14-09-04 |
| Mitsubishi | CT14MS1TX | Won't tune or store - pic blacks out when receiving RC command | IC702 X24C04P EEPROM | 14-09-04 |
| Mitsubishi | CT15MS1TX | Low sound aft being in st/by | EPROM IC702 changed | 14-09-04 |
| Mitsubishi | CT15MS1TX | No sound/pic all ht volts ok | IC702 X24C04 eeprom replaced | 14-09-04 |
| Mitsubishi | CT15MS1TX | Sound but no picture. Brightness, contrast & colour all at minimum. Returning these settings to normal brings back the picture but they return to minimum if the set is switched off then back on. | Replace faulty X24C04P EPROM (IC702).
| 14-09-04 |
| Mitsubishi | CT25MSTX E14 chassis | Dead - st/by led lights briefly at sw on | dry joints on IC951.
Drys were also found on regulators IC952, IC954 & IC955. | 14-09-04 |
| Mitsubishi | EE2 CT14MS1L | Stuck in AV mode | Check for cracks around tuner lugs | 14-09-04 |