| Make | Model | Problem | Solution | Date |
| | | |
| Found: 9
|
| Decca | D14RFG5 | Lines at bottom when heated | FOP IC TEA8172 | 14-09-04 |
| Decca | D14RFG6 | Dead - no LED | Q404 s/c, Q801 s/c, D805 s/c, R814 o/c & 2A fuse blown | 14-09-04 |
| Decca | D14RFG6 | Goes off aft 10 mins with led flashing 4 times | check R909/R913/R922 all 180K on the crt base | 14-09-04 |
| Decca | D14RFG7 | Shuts down at sw on | s/c in crt htrs to chassis- cut print to earth side of crt htrs & fit 1N4005 between htr pin & chassis | 14-09-04 |
| Decca | D20RFG5 | Int trips with 4 LED flashes | R909 R913 R922 on CRT Base (All 180K) | 14-09-04 |
| DECCA | D20RFG5 | MY TV POWERS OFF AFTER A FEW SECONDS. IF I SWITCH ON AND OFF SEVERAL TIMES THEN EVENTUALLY THE SET STAYS ON. | replace ALL the electrolytic capacitors in the power supply and this will fix your poor start up.
| 22-08-05 |
| Tatung | F Series V14RFG1G | Blank raster at switch on OSG ok .Then goes to trip mode. Leds flash 4 times in a cycle | Replace R909.R913.R922 all 180k on CRT base board. | 14-09-04 |
| Tatung | V14RFG1P | dead, PSU blown | fit PSU kit 9813136 | 14-09-04 |
| Tatung | V14RFG1P | starts up with sound but no pic and reverts to stby after 5 sec | R909 ,R913, R922 180k gone high | 14-09-04 |