| Make | Model | Problem | Solution | Date |
| | | |
| Found: 172
|
| Akai | CT2567 | St/by only | timing constant capacitor for the standby IC is leaky. The IC is mounted on a heatsink in the middle of the board. C093 is a pair of surface mount capacitors [in parallel] connected between pins 2 and 4 of the IC. Remove these capacitors and replace them with a 220nf. | 14-09-04 |
| Akai | CT2579 | 2 inch gap at rh side | C516 470pf 1.6kv next to lop tx | 14-09-04 |
|
|
| Akai | CT2579N | Steady, Oversized pic | C513 scan corr cap dry joint | 14-09-04 |
| Akai | CT2585 | Dead - lop tr s/c | Dry joints & line dr tr T507 BD337-25 int causing arcing noise | 14-09-04 |
| Goldstar | CIT2570F | Field cramped & foldover with no lum for first 2 mins | C308 2200µ in 16.5v rail hi esr | 14-09-04 |
| Goldstar | CIT2588 | Pic int blanks out (no lum) | Replace VC53 on Txt pcb | 14-09-04 |
| Goldstar | CIT2588F | PICTURE BLANKS OUT INT. | VC53 Pt No 181-169A | 14-09-04 |
| Goldstar | PC12B CIT2570F | Lines over pic & no R/C operation | C827 1000µ 25v, C830 470µ 16v | 14-09-04 |
| Hitachi | CPT2508 | Dead | Q901,IC901,R901,ZD901 4v7,D904,R913,C928 and C919. Also there was blown print between D904 and ZD901. | 14-09-04 |
| Hitachi | CPT2508 | Dead - Field coupling cap C610 100µ 25v exploded | Low res across 152v line due to s/c between field & line scan coils | 14-09-04 |
| Hitachi | CPT2508 | Tripping | Replace C910 & 916 33µ 10v; C919 4n7 2kv; C927 2n2 2kv. Change C914 to 10µ, check C909 150µ 400v, R919, R920, R931 & R932 | 14-09-04 |
| Hitachi | CPT2589 | FRAME COLLAPSE | REPLACE R715 AND IC601 | 14-09-04 |
| Hitachi | CPT2598 | Field coll | R715 1R safety res, TDA3654 fop chip, D601 | 14-09-04 |
| Hitachi | CPT2598 | No colour - ok on Txt | Chroma delay line | 14-09-04 |
| Hitachi | CPT2598 | Wavering picture with colour
dropout which would randomly blank out to a blue
screen in short bursts. Occasionally there would
be no sound or vision at switch-on and only the
channel change working. | Replace C933 (2,200uF 25V) whose ESR
had risen to 27 and C932 (470uF 16V) whose ESR
had risen to 48. These two capacitors sit next to each
other between the delay line and a heat sink. They
were replaced with high temperature types. | 14-09-04 |
| Hitachi | G7P MkII CPT2508 | Dead - LOPTr blows | IC701 TDA2579 | 14-09-04 |
| Hitachi | G7P MkII CPT2508 | Pic pulls to right when heated | Q905 connection to pcb suspect - resolder | 14-09-04 |
| ITT | CT2500 CVC1150 | Dead. | TR716 , 715 , D685 s/c , caused by TR731 ( BC328-52 ) s/c , D714 | 14-09-04 |
| ITT | CT2512 CVC1200 | No EHT. | TR741 ( BC328 ) right hand side of chassis. | 14-09-04 |
| ITT | CT2512 CVC1200 | No go Standby LED on. | R744 o/c right hand side of chassis. | 14-09-04 |
| Mitsubishi | Euro 10 CT2525TX | Field collapse | no 12v to pin 3 of frame Ic due to o/c corroded print from leaky cap. | 14-09-04 |
| Mitsubishi | CT21AV1 CT25AV1 | Failure of Q552 | Order & fit AVM5KIT | 14-09-04 |
|
|
| Mitsubishi | CT21AV1 CT25AV1 | Tuning drift mainly at top end of band | Add ( 180K ) & Diode ( IN4148 ) in series cathode of diode to 5V pin 6 Tuner & res to Tuning Voltage line pin 2 | 14-09-04 |
| Mitsubishi | CT21M1BM CT25M1 | POPPING NOISE IN STBY WORKS OK WHEN ON | Q951 Q952 OR DRYS ON CONNECTOR PB , R954 , R974 , R985 | 14-09-04 |
| Mitsubishi | CT21M5B CT25M5B | Tuning drift mainly at top end of band | Add ( 180K ) & Diode ( IN4148 ) in series cathode of diode to 5V pin 6 Tuner & res to Tuning Voltage line pin 2 | 14-09-04 |
| Mitsubishi | CT2525 | Dark pic - long time to come on | C906 100µ 50v leaky | 14-09-04 |
| Mitsubishi | CT2525 | Flyback lines at top of pic | C411 100µ near fop chip | 14-09-04 |
| Mitsubishi | CT2525 | Int dead esp when cold | C906 47µ 25v, C905 220µ 25v, C912 4µ7 50v | 14-09-04 |
| Mitsubishi | CT2525 | Int various inc no start up, display/analogue settings int | Check electrolytics in psu esp C956, C959, C962, & C964 | 14-09-04 |
| Mitsubishi | CT2525 | No Sound/pic with int trip - HT low | Z951 630mA fuible link | 14-09-04 |