| Make | Model | Problem | Solution | Added | Date |
| | | | |
| Found: 917 |
| Sony | AE-2B | LED flashing slowly - no go | field fault - dry joints fop chip IC501 | plamensl | 14-09-2004 |
| Sony | AE-2B | No chan store & poor geometry LEDs flashing | SDA line low due to D071 zener 5.6v leaky | plamensl | 14-09-2004 |
| Sony | AE-2B | no pic except on AV chan | all progs set to ext in preset memory - in service mode set to INIT BYTE | plamensl | 14-09-2004 |
| Sony | AE-2B | random characters appear on screen | three point cure. Change IC002 to 8-759-361-42, add Q004 DTC144EK to existing print pattern on M2 board, connect base Q2002 to collector Q004 | plamensl | 14-09-2004 |
| Sony | AE-2B KVA2542U | if all external speakers are connected then sound cuts out after 10 min, Ok if centre speaker is removed | R627 27R gone high (124939811) | plamensl | 14-09-2004 |
| Sony | AE-2B KVA2542U | stuck in stby with LED flashes 13 times, frame IC was replaced | disable protection and switch on, if you get frame foldover at bottom replace scan coils (873385305) | plamensl | 14-09-2004 |
| Sony | AE-2B KVA2942U | dead, no 300V supply | R614 18k 3W o/c on LOPTx pin 8 (121648811) | plamensl | 14-09-2004 |
| Sony | AE-2B KVA2942U | sound cuts out after 20-30 min, pic Ok | R626 27R 0.25W safety gone high | plamensl | 14-09-2004 |
| Sony | AE-2B KVG2515 | no satellite reception | Q3001 2SC2412K leaky | plamensl | 14-09-2004 |
| Sony | AE-2B KVX2972U | no pic, no sound, line stage working | R804 1k o/c (no 140V on CRT) | plamensl | 14-09-2004 |
| Sony | AE-2B KVX2972U | no pic, sound Ok | R701 680k o/c on CRT | plamensl | 14-09-2004 |
| Sony | AE-2F | Supply lines all low - partial operation | same on dummy load - R641 1M & check R642 | plamensl | 14-09-2004 |
| Sony | AE-2F KV2942U | no power | C609 22uF 25V | plamensl | 14-09-2004 |
| Sony | AE-5 KV32FX60U | int. pic would flick off for a split second | incorrect factory settings, enter features menu and switch auto format to OFF, enter setup menu and switch AV1,2,3 to OFF | plamensl | 14-09-2004 |
| Sony | AE-5A KV36FS70 | stuck in stby | IC6654 KA78R05 5V regulator on D PCB | plamensl | 14-09-2004 |
| Sony | AE1 | Blank screen with flyback lines | R805 ( 1R2 ) o/c | plamensl | 14-09-2004 |
| Sony | AE1 | Blank screen, no tuning memory when heated | Memory chip IC003 (M58655P) used in AE1 chassis requires -30V on pin 2 to operate. If -30V is lost, no station memory - check L807 for o/c in LOP when warm. L807 used as voltage dropper to reduce volts derived from transformer & its inductance (10mH) is important. It should always be replaced with original part, otherwise damage will occur - part no 1-407-504-00. | plamensl | 14-09-2004 |
| Sony | AE1 | Burning smell | Dry joints R614 - can fit in alternative posn; check R611 & L607 for o/c | plamensl | 14-09-2004 |
| Sony | AE1 | CAN'T STORE STATIONS PIN 2 ICOO3 NOT -33v | L807 OC PtNo 140750400 also check R008 C017 | plamensl | 14-09-2004 |
| Sony | AE1 | Chans won't store - int | The -30v supply to IC003 M58655 Memory chip falls to -15v. L807 feed coil was int o/c | plamensl | 14-09-2004 |