|Information about the files in archive:|
|File name||Text |
|R21AT-002.pdf||A30317, SUK R-21AT O/M
(with terms of Guarantee)
IMPORTANT Carefully read the Operation Manual before installing or using the microwave oven. Pay special attention to the Important Safety Instructions, see Page 4. Always use the Manual with the oven and keep it near to enable easy reference.
A30317, SUK R-21AT O/M
AC Line voltage ... Single phase 230-240V, 50Hz AC Power required ... 1.55kW Output power ... 1000W (IEC 705) Microwave frequency ... 2450MHz *(Class B / Group 2) Outside dimensions ... 520(W) x 309(H) x 406(D) mm Cavity dimensions ... 351(W) x 211(H) x 372(D) mm Oven capacity ... 1.0 cu.ft (28 litres) Cooking uniformity ...|
|R21AT-005.pdf||MWO2000 02 01 MICROWAVE TECHNICAL BULLETIN
MODELS R21AT Month of Issue: February 2000 Classification: White Page 1 of 1
From the August 1999 production (serial numbers starting with the digits 9910) the chassis support (item 4-18) has been changed. Both the new and old parts are completely interchangeable.
Please update your Service Manual with the part number given below.
REF NO 4-18
DESCRIPTION Chassis support
PART NUMBER LANGFA199WRWZ
PRICE CODE AH
Sharp Electronics (UK) Limited
Reference EHKE445 Revision 1
White Carry out as required Yellow Carry out as required and whenever the unit comes in for service Red Carry out on all units|
|R21AT-006.pdf||MICROWAVE TECHNICAL BULLETIN
MODELS All microwave ovens
Month of Issue: Classification:
MWO2000 05 02
May 2000 White Page 1 of 1
SYMPTOM Localised 'scorch' marks on the oven cavity faceplate and/or the door sub-assembly following normal operation. CAUSE Variation in the sealing gap between the door sub-assembly sealer plate and oven cavity faceplate could lead to localised scorching. This phenomenon can be aggravated by abnormal usage such as no-load operation.
Suggested repair methods are as follows: 1. Stainless Steel Cavities Providing the scorching is not of a severe nature: I. II. Rub the cavity faceplate down to remove marks. This can be achieved by use of a suitable grade of wire wool ensuring a uniform finish is obtained. Replace the door assembly.
2. Painted Cavities Unfortunately in these cases there maybe no option but to replace both oven cavity and door sub-assembly, dependant on scorching severity.
IMPORTANT Normal service procedures should follow any repai|
COMMERCIAL MICROWAVE OVEN
ON DEF NO. X2 CHECK
In interests of user-safety the oven should be restored to its original condition and only parts identical to those specified should be used.
TABLE OF CONTENTS
Page SERVICING ... INSIDE FRONT COVER CAUTION, MICROWAVE RADIATION ... 1 WARNING ... 1 PRODUCT SPECIFICATIONS ... 2 GENERAL INFORMATION ...|