Philips 107s2-p14 free download

File name 107s2-p14.pdf

14 107S2 CM23 GS III Mechanical Instructions 9 Go to cover page 0. General To be able to perform measurements and repairs on the "circuit boards", these unit should placed in the service position first. 1.Remove the rear cover -Remove right and left lib on the back cover -Open 4 lids with "-" type screwdriver. -Remove 4 screws at the bottom cabinet with "+" type screwdriver,refer fig 2. lids -Remove out back cover. 2. Video panel a.Cutoff all wire cable ties b.Remove GRD wire between video shield and CRT rack. c.Remove 1 screw between mains board rack and video shield d. cutoff 1 cable tie on LOT wire e.Remove GRD wire (1604)from video PCB to CRT rack. 3. Main panel - Disconnect the degaussing coil (1113)from Main panel. - Remove the video panel from CRT. - Remove the "screw" of I/F cable from Main panel. - Disconnect the CRT ground "M312" from Video panel. - Disconnect the Hi-Pot cap from CRT. - Disconnect yoke wire from "M401". - Disconnect concellation connector(1402). - Slide the main panel out of bottom tray. lid - Connect yoke wire to "M401". - Connect concellation connector(1402).". - Place Main panel in service position as shown in Fig.1. - Mount Video panel again on CRT. - To connect Hi-Pot cap again. - To connect "M312" again. Fig.2 screws Fig.1 Fig.3 screws Fig.3 Back Forward