|HP 54825A_45A Programmer.pdf||Programmer's Reference
Publication Number 54810-97076
This reference applies directly to software revision code A.04.20 and later.
For Safety information, Warranties, and Regulatory information,
see the pages at the end of this book.
Copyright Agilent Technologies 1997-2002
All Rights Reserved.
Programming Command Set
In This Book
This book is your guide to programming the Infiniium-Series Oscilloscopes.
Chapters 1-5 give you an introduction to programming the oscilloscopes, along
with necessary conceptual information. These chapters describe basic program
communications, interface, syntax, data types, and status reporting.
Chapter 6 shows example BASIC and C programs, and describes chunks of one
program to show you some typical applications. The BASIC and C example
programs, and a "readme" file are also shipped on a disk with the oscilloscope.
Chapters 7-24 describe the commands used to program the Infiniium-Ser|