Information about the files in archive: |
Decompress result: | OK |
Extracted files: | 3 |
File name | | Text |
Pages from Ph3130Service_part1-1.pdf | | LASER PRINTER
Phaser 3120 Phaser 3130 Phaser 3115
SERVICE
LASER PRINTER
Manual
CONTENTS
1. Precautions 2. Specifications 3. Disassembly and Reassembly 4. Troubleshooting 5. Exploded Views and Parts List 6. Block Diagram 7. Connection Diagram 8. Schematic Diagram
Precautions
1
1. Precautions
The cautions in the below are items needed to keep in mind when maintaining and servicing. Please read carefully and keep the contents in mind to prevent accidents while servicing and to prevent that the machine gets damage.
1.1 Warning for safety.
(1) Request the service by qualified service person. The service for this machine must be performed by a service person who took the additional education of this field. It is dangerous if unqualified service person or user tries to fix the machine. (2) Do not rebuild it discretionary. Do not attach or change pats discretionary. Do not dissemble, fix, and rebuilt it. If do, printer will abnormally work and electric shock or a fire can be occurred. |
Pages from Ph3130Service_part1-2.pdf | | Specifications
2-4
Service Manual
Disassembly and Reassembly
3
3. Disassembly and Reassembly
3.1 General Precautions on Disassembly
Releasing Plastic Latches
Many of the parts are held in place with plastic latches. The latches break easily; release them carefully. To remove such parts, press the hook end of the latch away from the part to which it is latched.
When you disassemble and reassemble components, you must use extreme caution. The close proximity of cables to moving parts makes proper routing a must. If components are removed, any cables disturbed by the procedure must be restored as close as possible to their original positions. Before removing any component from the machine, note the cable routing that will be affected.
Whenever servicing the machine, you must perform as follows:
1. Check to verify that documents are not stored in memory. 2. Be sure to remove the toner cartridge before you disassemble parts. 3. Unplug the power cord. 4. Use a flat and clean surface. |
Ph3130Service_part2.pdf | | TROUBLESHOOTING
4
4. Troubleshooting
4.1 How to use DCU
4.1.1 DCU Setup
You can examine the malfunction of the printer. To perform DCU, open the front discharge cover and leave the connect the harness wire(10 pin/4 pin) to the CN10(4 pin) of the Main control board.
ML SERIES DIAGNOSTIC CONTROL UNIT
04 DEV 300 05 LSU READY 07 PAPER EMPTY 08 DEV 350 LSU MT & LD PAPER WIDTH EXIT SENSOR DEV 350 LSU MOTOR NEW CRU FEED SENSOR
SELF TEST
STATUS DIAGNOSTIC
09 COVER OPEN 10 COER HEATING PRINTING TEMP READY HEAT
ON
DIAGNOSTIC CODE
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14
MAIN MOTOR OPERATING SYSTEM MAIN HIGH-VOLTAGE ON TRNSFER HIGH-VOLTAGE (-)ON THV(+) REFERANCE VOLTAGE DEV/SUPPLY HIGH-VOLTAGE ON/PTL ON LSU OPERATING SYSTEM PICKUP CLUTCH ON PEEMPTY/PWITH/NEW CRU TEST FEED & EXIT SENSOR TEST COVER OPEN SENSOR TEST FUSER TEST HOT BURN TEST CLEAN MODE PRINT THV(+)TRIGGER, ALL HV & FAN ON THV(+) REFERENCE ON
OFF
STATUS CODE
61
WARM UP
00 01 02 03 04 20 30 40 50 69
READY READY READY RE |