Keithley DMM7510-903-01A Nov 2014 web free download

File name DMM7510-903-01A_Nov_2014_web.pdf

Model DMM7510 Quick Start Guide Safety precautions Service personnel are trained to work on live circuits, perform safe installations, and repair products. Only properly trained service personnel may perform installation and service procedures. Observe the following safety precautions before using this product and any associated in- Keithley Instruments products are designed for use with electrical signals that are strumentation. Although some instruments and accessories would normally be used with measurement, control, and data I/O connections, with low transient overvoltages and nonhazardous voltages, there are situations where hazardous conditions may be present. must not be directly connected to mains voltage or to voltage sources with high transient This product is intended for use by qualified personnel who recognize shock hazards overvoltages. Measurement Category II (as referenced in IEC 60664) connections and are familiar with the safety precautions required to avoid possible injury. Read and require protection for high transient overvoltages often associated with local AC mains follow all installation, operation, and maintenance information carefully before using the connections. Certain Keithley measuring instruments may be connected to mains. These product. Refer to the user documentation for complete product specifications. instruments will be marked as category II or higher. If the product is used in a manner not specified, the protection provided by the product Unless explicitly allowed in the specifications, operating manual, and instrument labels, do warranty may be impaired. not connect any instrument to mains. The types of product users are: Exercise extreme caution when a shock hazard is present. Lethal voltage may be present Responsible body is the individual or group responsible for use and maintenance of on cable connector jacks or test fixtures. The American National Standards Institute equipment, for ensuring that the equipment is operated within its specifications and (ANSI) states that a shock hazard exists when voltage levels greater than 30 VRMS, operating limits, and for ensuring that operators are adequately trained. 42.4 VPEAK, or 60 V DC are present. A good safety practice is to expect that