Keithley 707B-903-01 free download

File name 707B-903-01.pdf

Models 707B and 708B Quick Start Guide Observe the following safety precautions before using this product and any associated Service personnel are trained to work on live circuits, perform safe installations, and instrumentation. Although some instruments and accessories would normally be used repair products. Only properly trained service personnel may perform installation and with non-hazardous voltages, there are situations where hazardous conditions may be service procedures. present. Keithley Instruments products are designed for use with electrical signals that are rated This product is intended for use by qualified personnel who recognize shock hazards Measurement Category I and Measurement Category II, as described in the International and are familiar with the safety precautions required to avoid possible injury. Read and Electrotechnical Commission (IEC) Standard IEC 60664. Most measurement, control, and follow all installation, operation, and maintenance information carefully before using the data I/O signals are Measurement Category I and must not be directly connected to mains product. Refer to the user documentation for complete product specifications. voltage or to voltage sources with high transient over-voltages. Measurement Category II If the product is used in a manner not specified, the protection provided by the product connections require protection for high transient overvoltages often associated with local warranty may be impaired. AC mains connections. Assume all measurement, control, and data I/O connections are for connection to Category I sources unless otherwise marked or described in the user The types of product users are: documentation. Responsible body is the individual or group responsible for use and maintenance of Exercise extreme caution when a shock hazard is present. Lethal voltage may be present equipment, for ensuring that the equipment is operated within its specifications and on cable connector jacks or test fixtures. The American National Standards Institute operating limits, and for ensuring that operators are adequately trained. (ANSI) states that a shock hazard exists when voltage levels greater than 30V RMS, Operators use the product for its intended function. They must be trained in electrical 42.4V peak, or 60VDC are present. A good safety practice is to expect that hazardous safety procedures and proper use of the instrument. They must be protected from voltage is present in any unknown circuit before measuring. electric shock and contact with hazardous live circuits.