Keithley Quick Start Guide free download

File name Quick Start Guide.pdf

Series 2200 power Supplies Quick Start Guide Front Panel Operation STEP 1 Setting the Output Voltage 1. Press V-Set. 2. Use the arrow keys, numeric keypad, or the navigation wheel to enter the desired voltage output value. 3. Press Enter to set the voltage. STEP 2 Setting the Current Limit 1. Press I-Set. 2. Use the arrow keys, numeric keypad, or the navigation wheel to enter the current limit. 3. Press Enter to set the current. STEP 3 Turning on the Output 1. Press Output ON/OFF Remote Operation The following SCPI command example resets the power supply, sets the voltage output to 3.33V, the current limit to 1.6A and turns the output on. *RST SOURCE:FUNC:MODE FIX SOURCE:VOLT 3.33V SOURCE:CURR 1.6A SOURCE:OUTP:ON Connecting a Device OPTION 1 Using Local Sense (Lead Wire Resistance not Compensated) 1. Install the shorting clip (included in accessories) on the rear panel terminal strip as shown in Figure 1 below. You may also use jumpers between DRIVE+ and SENSE+, and between DRIVE- and SENSE-. Figure 1 Rear Panel Shorting Clips 2. Connect two wires from either the front panel binding posts, as shown in Figure 2 below, or the rear panel DRIVE+ and DRIVE- terminals to your device under test. Figure 2 Connecting a Device to the Front Panel OPTION 2 Using Remote Sense (Lead Wire Resistance Compensated) 1. Remove any jumpers or the shorting clip on the rear panel terminal strip connectors between DRIVE+ and SENSE+ and between DRIVE- and SENSE-. 2. Connect a pair of leads from SENSE+ and SENSE- to the device under test as shown in Figure 3 below. (NOTE: To assure system stability, use a jacketed, twisted-pair cable between the remote sense terminals of the Series 2200 and the load.) 3. Connect a pair of leads from the DRIVE+ and DRIVE- to the device under test as shown, again, in Figure 3. Figure 3 Connecting a Device to the Rear Panel