| Make | Model | Problem | Solution | Added | Date |
| | | | |
| Found: 711 |
| Sharp | 5BSA 51AT15H | powers up from mains switch, LED flashes then goes out with no pidc or sound. When switched off high pitched noise comes from speaker going down in frequency | DJ on D710 and C713 1000uF 25V s/c | plamensl | 14-09-2004 |
| Sharp | 5BSA 51AT15H | short pic & no reponse to front or R/C | Q509 BC635, Q510 BC338 next to field o/p pair & C713 100µ 16v | plamensl | 14-09-2004 |
| Sharp | 5BSA 51AT15H | Slow start, cogging, loptr failure or tripping | Replace all 6 elects on psu sec & Q704/708 BC338-40 5v reg trs & Q601 BU508DFI LOPTr | plamensl | 14-09-2004 |
| Sharp | 5BSA 51AT15H | Small pic - HT low (should be 108v) | Check D716 27v & D717 75v zeners by replacement | plamensl | 14-09-2004 |
| Sharp | 5BSA 51AT15H | Snowy raster only | No 12v to tuner - R243 5R6 1/2w o/c also check C713 1000µ 35v in -10v supply for various faults | plamensl | 14-09-2004 |
| Sharp | 5BSA 51AT15H | Three col flyback lines at top of screen | D504 & D507 1N4148 | plamensl | 14-09-2004 |
| Sharp | 5BSA 51AT15H | To reprog NVM for AFT/AGC | Auto tune tv to a chan, fine tune for best result then go into service mode, go to AFT adj, & press key symbol | plamensl | 14-09-2004 |
| Sharp | 5BSA 51AT15H | vertical picture shift, alters with temperature | replace R512 180k 0.5W next to Q508 | plamensl | 14-09-2004 |
| Sharp | 5BSA 51AT15H | whistling noise and picture tearing for first 3 min from cold | C604 220uF 10V in PSU | plamensl | 14-09-2004 |
| Sharp | 5BSA 51AT15H/15AT151R | Dead st/by only - led goes out when chan no. pressed | No line drive pin 12 MC4407 IC801 as no 5v supply at pin 35. Q708 BC338-40 st/by tr s/c | plamensl | 14-09-2004 |
| Sharp | 66AS06H | Shuts down aft 1 sec with R632 going o/c | C619 560nF 250v - also check R632 & R619 39R 1/2w | plamensl | 14-09-2004 |
| Sharp | 66CS-03H | Slow start up from cold - LEDs flash Gn/or | Check dry joints & C714 1000µ 25v D712 reservoir cap | plamensl | 14-09-2004 |
| Sharp | 66CS03 | BLOWING LINE O/P TRANSISTOR | RESOLDER DRY JOINTS ON SCAN COIL PCB | plamensl | 14-09-2004 |
| Sharp | 66CS03 | St/by only | Leaky blue disc ceramic cap 2n2 2kv on underside of pcb | plamensl | 14-09-2004 |
| Sharp | 66CS03 | Tripping | C714 1000µ 10v & LOPTx arcing - check also dry joints scan coils | plamensl | 14-09-2004 |
| SHARP | 66CS03H | DEAD | CHECK C601 FOR S/C (FITTED UNDER D605 ON PRINT SIDE IS BLUE DISC TYPE) | plamensl | 14-09-2004 |
| Sharp | 66CS03H | DEAD | CHECK C601 FOR S/C (FITTED UNDER D605 ON PRINT SIDE IS BLUE DISC TYPE) | plamensl | 14-09-2004 |
| Sharp | 66CS03H | Dead - LOPtr s/c | replace C604, C714 & check dry joints scan coil pcb | plamensl | 14-09-2004 |
| SHARP | 66CS03H | DEAD BUT COMES ON AFTER A WHILE | REPLACE C714 1000MFD25V | plamensl | 14-09-2004 |
| Sharp | 66CS03H | Field scan distorted in upper half | 45v supply at C619 only 15v. R643 5R6 overheating, D623 10v zener sm leaky, R632 1A cct prot o/c | plamensl | 14-09-2004 |